The Drive Harness from EzyDog is a car safety harness for your dog. Both a travel harness and a walking harness, your dog is secured while in transit and ready for the drive.
Warning: Last items in stock!
By buying this product you can collect up to 9 loyalty points. Your cart will total 9 points that can be converted into a voucher of $1.80.
This car safety harness conforms to and has passed all relevant requirements for the following standards: USA (FMVSS 213) Europe (ECE Regulation 16) Australia (ADR42/04)
Simply feed the seat belt through both webbing handles on the top of the harness, click the buckle into the seat belt of your car and you're ready for the Drive.
You only have to fit the harness to your dog once (see 'Fitting Instructions tab for Instructions) From then on, the Harness can be taken on/off very quickly using the Mag-Lok™ Instant Fit closure system.
We have included two stainless steel D-rings to the top of the harness for leash attachment, so that you don't have to switch from Car to Walking Harness when you get to your destination.
We have used only the strongest and high quality materials in this product. The Tri-Glides are made from Aluminum Alloy, so they are light, durable and incredibly strong.
All webbing is made from vehicle-tested seat belt webbing and the Crosslink™technology ensures that the harness is the ultimate in strength.
The Chest Plate section is padded and contoured to mold to the shape of the dog for a custom fit
Regularly inspect your harness for any signs of damage and excessive wear including:
ALWAYS REPLACE HARNESS IF SHOWING SIGNS OF DAMAGE
Hand wash in mild detergent and air dry in shade.
Store in a dry place, out of direct sunlight.
For best fit measure the girth of the dog. This is the area behind the front legs and around the body. The neck will typically fall into place once girth is determined. If the measurement is close to the end of the size range, go up to the larger size.
|Size||Girth (cm and in)|
|S||28 - 64 cm||11 - 25 in|
|M||38 - 86 cm||15 - 34 in|
|L||49 - 106 cm||19 - 42 in|
1. UNLACE AND LOOSEN WEBBINGS FROM ALLOY TRI GLIDE. PLACE HARNESS ON DOG
2. ADJUST BOTH FRONT CHEST WEBBINGS TO A FIRM FIT. USE MEASUREMENTS TO BALANCE WEBBING LENGTHS REPEAT ADJUSTMENT TO REAR GIRTH WEBBINGS
3. LOCK ALL FOUR WEBBINGS IN PLACE BY FEEDING BACK THROUGH ALLOY TRIGLIDE
4. FEED WEBBING TAIL UNDER WEBBING KEEPER AND LOCATE KEEPER BACK AGAINST TRIGLIDE. FOLD EXCESS WEBBING AND SECURE IN KEEPER
5. PLACE FITTED HARNESS ON DOG AND POSITION IN CAR. THREAD SEAT BELT THROUGH BOTH HANDLES AND CLICK INTO BUCKLE. REMOVE SLACK FROM SEAT BELT
IMPORTANT: DO NOT OVER-TIGHTEN STRAPS! WHEN FITTED CORRECTLY, HARNESS SHOULD BE SNUG, BUT TWO FINGERS SHOULD EASILY RUN BETWEEN STRAPS & DOG.